Lock Starter pack – two lock pack for YNOTLOC

• Simple installation requiring only a Philips head screw driver
• Magnetic sensors plug into rear of locks, sensor wires must then be positioned to accommodate magnetic wand use.
  Note: Sensor wire must not be mounted near any metal parts (mount away from hinges, metal drawer runners, handles and fasteners), and wire end (sensor) must be at least 50 mm away from lock and other sensors.
• Locks automatically when door/drawer closes – unlocks when magnetic wand is held near sensor
• When enabled, the manual overdrive on strike face will stop door/drawer from locking
• Powered by wall mount low voltage power supply, for use in standard 120 volt wall receptacle
• System draws power only when switch is activated (when unlocking doors/drawers) – requires no power when locked
• Fail secure operation only

1 set (includes mounting hardware, wire clips and instructions)

2 Cabinet/drawer locks, unhanded
2 Strikes, shim packs
1 Magnetic Wand
1 Power Supply, 12VDC, 500mA
2 Connecting power wires with self-adhesive clips
2 Magnetic sensors with wires and self-adhesive clips
2 Installation tools

No. of locks that can be daisy chained to single power supply:
If magnetic wand used; up to 30 locks (7x additional lock sets)
If master switch used; up to 10 locks (2x additional lock sets)

Specifications

(2) Cabinet/drawer locks, unhanded (includes 3 wood screws #6 x 1”)
Material:
Housing: plastic, white. Plunger: steel, chrome plated.
Dimensions: 2 5/8” x 1 3/16” x 1 3/16” (LxWxH)
Voltage: 12VDC
Amperage:  210 mA
Operating Temp: 5°F - 104°F
Holding force: 70 lbf.

(2) Strikes and shim sets (includes 3 wood screws #6 x 1”)
Material: Housing; plastic, white.
Dimensions: 1 3/16” x 1” x 1 1/8” (LxWxH)
Shims: 2 per strike, 1mm and 2mm thick
Operating Temp: 5°F - 104°F
Holding force: 70 lbf.

(1) Magnetic Wand
Material: Housing; Plastic, red.
Dimensions: 3 1/8” x 1/2” Dia. (LxD)
Holding force: 10 lbf.

(1) Power Supply, 12VDC, 500mA
Material: Housing; Plastic, Black. Secondary cord 6’ long, black.
Dimensions: 3” x 2 1/8” x 3” (LxWxH)
Voltage in: 120 VAC
Voltage out: 12VDC
Amperage: 500mA
Operating Temp: 5°F - 104°F
Certification:  UL listed

(1) Connecting power wires
Material: Plastic, white.
Dimensions: 39” x 3/16” (LxW)
Voltage rating: 12VDC
Power : 60W
Operating Temp: 5°F - 104°F
Connections:  2 end terminations, 3 attached cable clips.

(2) Magnetic sensors with wires
Material: Plastic, white.
Dimensions: 39” x 1/4” (LxW)
Voltage rating: 12VDC
Power :  60W
Operating Temp: 5°F - 104°F
Connections:  1 end termination, 1 reed contact sensor with mounting pad, 4 attached cable clips.

(2) Installation tools
Material: Housing; Plastic, blue.
Dimensions: 2 5/8” x 1 3/16” x 1 3/16” (LxWxH)