Titebond® III, Ultimate Wood Glue

• Waterproof – Passes ANSI/HPVA Type I Specification
• Superior strength
• Longer open time
• Lower application temperature
• Resists solvents, heat and mildew
• Unaffected by finishes
• Water cleanup & Non-toxic
• FDA approved for indirect food contact
• Sands easily without softening
• Safer than traditional waterproof glues

APPLICATION GUIDELINES

Application temperature: Above 47°F

Open assembly time: 8-10 minutes (70°F/50% RH)(

Total assembly time: 20-25 minutes (70°F/50% RH)

Minimum required spread: Approximately 6 mils or 250 square feet per gallon.

Required clamping pressure: Enough to bring joints tightly together (generally, 100-150 psi for softwoods, 125-175 psi for medium woods and 175-250 psi for hardwoods)

Methods of application: Plastic bottles for fine applications; glue may also spread with a roller spreader or brush.

Cleanup: Damp cloth while glue is wet. Scrape off and sand dried excess.

BOND STRENGTH ASTM D-905 (On Hard Maple)

LIMITATIONS

Not for continuous submersion or for use below the waterline. Not for structural or load bearing applications. Use when temperature, glue and materials are above 45°F. Store product below 75°. Storage above this temperature may cause product to thicken and reduce the usable shelf life. If thickened, shake vigorously by firmly tapping the bottle on a hard a surface until the product is restored to original form. Because of variances in the surfaces of treated lumber, it is a good idea to test for adhesion. For best results gluing exterior doors or exotic and oily woods, please contanct our Technical Support Team at 1-800-347-4583. Read MSDS before use.

NOTE: KEEP FROM FREEZING.

KEEP OUT OF THE REACH OF CHILDREN